Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:event_commands:event_maximum [2025/04/29 18:55] – [Example 1: Simple Use Case] wikisysop
+++ visual3d:documentation:pipeline:event_commands:event_maximum [2025/04/29 19:04] (current) – wikisysop
@@ Line 81: / Line 81: @@
 **Select Frame Offset:** 0\\
 **Signal Components:** X\\
-**Event Sequence:**RHS -> RHS (use arrows to move from defined events list into sequence.) \\
 **Event Sequence Instance:**0\\
-|{{:Event_Max_RKFlex_MaxLocal.jpg?400}}|<code>
+|{{:visual3d:documentation:pipeline:event_commands:eventmax_ex1_dialogbox.png?600|}}|<code>
 Event_Maximum
 /RESULT_EVENT_NAME=RKFlex_MaxLocal
@@ Line 94: / Line 93: @@
 ! /FRAME_OFFSET=0
 ! /TIME_OFFSET=
-/EVENT_SEQUENCE=RHS+RHS
+! /EVENT_SEQUENCE=
 ! /EXCLUDE_EVENTS=
 ! /EVENT_SEQUENCE_INSTANCE=0
@@ Line 113: / Line 112: @@
 **RKFlex_MaxLocal** will be created at the maximum values during the full gait cycle. As seen below:
-{{:visual3d:documentation:pipeline:event_commands:eventmax_ex1_corrected_graph.png?600|}}
+|{{:visual3d:documentation:pipeline:event_commands:eventmax_ex1_corrected_graph.png?600|}}|
 ==== Example 2: Complex ====
-In this example, the local maxima of the right foot vertical acceleration (Y-axis) during the full trial is identified. Then, the values of this event are extracted.
+In this example, the local maxima of the right foot angular acceleration during the full trial is identified. Then, the values of this event are extracted.
 Use the Event_Maximum command to find the peaks in the acceleration signal, the component is set to Y and frame window is increased to 60.