HAS-Motion Software Documentation

User Tools

Site Tools

You are here: Main Page » visual3d » documentation » pipeline » event_commands » Event Threshold
visual3d:documentation:pipeline:event_commands:event_threshold

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
visual3d:documentation:pipeline:event_commands:event_threshold [2025/04/29 13:39] – [Dialog] wikisysopvisual3d:documentation:pipeline:event_commands:event_threshold [2025/04/29 13:39] (current) – [Dialog] wikisysop
Line 75: Line 75:
   * **Label on Ascent/Descent**: Choose to place event when threshold is cross in an increasing signal (ascent) or decreasing signal (descent).   * **Label on Ascent/Descent**: Choose to place event when threshold is cross in an increasing signal (ascent) or decreasing signal (descent).
   * **Ensure Window Before/After**: Full frame window is available before or after detected point to avoid errors.   * **Ensure Window Before/After**: Full frame window is available before or after detected point to avoid errors.
-  * Event Sequence: Specify range in which to search for threshold crossings. +  * **Event Sequence**: Specify range in which to search for threshold crossings. 
-  * Event Subsequence: Specify subrange in which to search for threshold crossings.+  * **Event Subsequence**: Specify subrange in which to search for threshold crossings.
  
  
visual3d/documentation/pipeline/event_commands/event_threshold.txt · Last modified: 2025/04/29 13:39 by wikisysop