Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:event_commands:event_threshold [2025/04/29 13:39] – [Dialog] wikisysop
+++ visual3d:documentation:pipeline:event_commands:event_threshold [2025/08/21 18:14] (current) – wikisysop
@@ Line 47: / Line 47: @@
 |**!/FRAME_OFFSET=0**|Shifts the event forward or backward by a specified number of frames.|
 |**!/TIME_OFFSET=**|Shifts the event forward or backward by a specified time in seconds.|
-|**!/EVENT_SEQUENCE=**|Sequence of events within which the command is performed (i.e. RHS + RHS).|
+|**[[visual3d:documentation:c3d_signal_types:event_label_data_type|!/EVENT_SEQUENCE=]]**|Sequence of events within which the command is performed (i.e. RHS + RHS).|
-|**!/EXCLUDE_EVENTS=**|Events to be excluded from sequence.|
+|**[[visual3d:documentation:c3d_signal_types:event_label_data_type|!/EXCLUDE_EVENTS=]]**|Events to be excluded from sequence.|
 |**!/EVENT_SEQUENCE_INSTANCE=0**|Which instance of an event sequence to use.|
 |**!/EVENT_SUBSEQUENCE=**|Subsequence of events to analyze (i.e. LTO + LHS).|
 |**!/SUBSEQUENCE_EXCLUDE_EVENTS=**|Events to exclude from the subsequence.|
 |**!/EVENT_SUBSEQUENCE_INSTANCE=0**|Instance of the event subsequence to analyze.|
-|**!/EVENT_INSTANCE=**|Determines how many event occurrences to consider (0 for all, positive for sequential selection, negative for reverse selection).|
+|**[[visual3d:documentation:c3d_signal_types:event_label_data_type|!/EVENT_INSTANCE=]]**|Determines how many event occurrences to consider (0 for all, positive for sequential selection, negative for reverse selection).|
 |**!/THRESHOLD=**|Threshold value to trigger event detection.|
 |**!/ON_ASCENT=**|Determine if the event is detected when the signal crosses the threshold in an upward direction.|