visual3d:documentation:pipeline:file_commands:file_save
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
visual3d:documentation:pipeline:file_commands:file_save [2025/06/02 17:35] – wikisysop | visual3d:documentation:pipeline:file_commands:file_save [2025/06/09 20:49] (current) – wikisysop | ||
---|---|---|---|
Line 7: | Line 7: | ||
* If no CMZ file is active (e.g., untitled or no file has been opened), Visual3D will prompt the user to specify the file name and location for saving. | * If no CMZ file is active (e.g., untitled or no file has been opened), Visual3D will prompt the user to specify the file name and location for saving. | ||
- | **Important Note**: This command is for saving over the currently open CMZ file, not creating a new one ("Save As"). | + | **Important Note**: This command is for saving over the currently open CMZ file, not creating a new one ("[[visual3d: |
===== Pipeline Command ==== | ===== Pipeline Command ==== | ||
Line 117: | Line 117: | ||
</ | </ | ||
+ | ===== Notes ===== | ||
+ | * File_Save should be placed at the end of your pipeline unless intermediate saves are being made. | ||
+ | * If batch processing, always verify the file opened with ' | ||
[[Visual3D: | [[Visual3D: |
visual3d/documentation/pipeline/file_commands/file_save.1748885727.txt.gz · Last modified: 2025/06/02 17:35 by wikisysop