visual3d:documentation:pipeline:metric_commands:metric_vector_between_events
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
visual3d:documentation:pipeline:metric_commands:metric_vector_between_events [2024/07/17 15:46] – created sgranger | visual3d:documentation:pipeline:metric_commands:metric_vector_between_events [2025/09/19 19:11] (current) – wikisysop | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Metric Vector Between Events ====== | ====== Metric Vector Between Events ====== | ||
+ | ====Overview==== | ||
- | This command creates a metric vector of a signal(s) value between a start and an end event. | + | This command creates a metric vector of a signal(s) value between a start and an end event, for example the metric vector of stride length while the foot is in contact with the ground. It can be found within the **Pipeline Workshop** under **Metric**. |
+ | ====Pipeline Command==== | ||
+ | |||
+ | The syntax for the function is as follows: | ||
+ | |||
+ | < | ||
+ | Metric_Vector_Between_Events | ||
+ | ! / | ||
+ | / | ||
+ | ! / | ||
+ | / | ||
+ | ! / | ||
+ | / | ||
+ | / | ||
+ | ! / | ||
+ | / | ||
+ | / | ||
+ | / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ; | ||
+ | </ | ||
+ | |||
+ | ====Command Parameters==== | ||
+ | |||
+ | The following table shows the command parameters seen above and their descriptions: | ||
|**Metric_Vector_Between_Events** | |**Metric_Vector_Between_Events** | ||
|**/ | |**/ | ||
Line 16: | Line 43: | ||
|**/Append to Existing Values=** | |**/Append to Existing Values=** | ||
- | \\ | + | ====Dialog==== |
- | The command can be edited in the text editor of the pipeline workshop or can be edited from a dialog. The dialog that pops up when pipeline selection is edited by double clicking with the left mouse button. The example below shows the dialog. | + | |
- | + | ||
- | ==== Example: Stride Length Vector for Gait ==== | + | |
- | The dialog | + | The command can be edited in a text editor or in a dialog |
{{: | {{: | ||
+ | |||
+ | The dialog box allows you to assign values to the command parameters outlined above. | ||
+ | |||
+ | ==== Example: Stride Length Vector for Gait ==== | ||
The command looks like this in the text editor: | The command looks like this in the text editor: | ||
Line 49: | Line 77: | ||
\\ | \\ | ||
- | |||
- | |||
==== Example: Stride Length Vector for Throwing ==== | ==== Example: Stride Length Vector for Throwing ==== | ||
visual3d/documentation/pipeline/metric_commands/metric_vector_between_events.txt · Last modified: 2025/09/19 19:11 by wikisysop