Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:metric_commands:remove_metrics_by_threshold [2024/06/19 13:37] – removed sgranger
+++ visual3d:documentation:pipeline:metric_commands:remove_metrics_by_threshold [2025/09/22 18:32] (current) – [Pipeline Command] wikisysop
@@ Line 1: / Line 1: @@
+====== Remove Metrics By Threshold ======
+====Overview====
+The command **Remove Metrics by Threshold** removes metrics above or below a threshold, allowing you to keep those within the range, or outside the range. This can be useful when trying to isolate data within a certain signal range, or when trying to isolate outliers. If a component is removed, all components at that frame are removed. The command can be found within the **Pipeline Workshop** under **Metric**.
+====Pipeline Command====
+The syntax for the function is as follows:
+<code>
+Remove_Metrics_By_Threshold
+! /METRIC_FOLDERS=
+/METRIC_NAMES=
+/METRIC_COMPONENTS=
+! /REMOVE_METRICS_ABOVE=
+! /REMOVE_METRICS_BELOW=
+;
+</code>
+====Command Parameters====
+The following table shows the command parameters seen above and their descriptions:
+|**Remove_Metrics_By_Threshold**|                                          |
+|**/Metric_Names=**             |The names of the metrics                  |
+|**/Metric_Folders=**           |The folders of the metrics                |
+|**/Metric_Components=**        |The components of the metrics to be tested|
+|**/Remove_Metrics_Above=**     |An Expression                             |
+|**/Remove_Metrics_Below=**     |An Expression)                            |
+====Example====