Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:metric_commands:remove_metrics_by_threshold [2024/07/12 14:05] – created sgranger
+++ visual3d:documentation:pipeline:metric_commands:remove_metrics_by_threshold [2025/09/22 18:32] (current) – [Pipeline Command] wikisysop
@@ Line 1: / Line 1: @@
-====== Remove_Metrics_By_Threshold ======
+====== Remove Metrics By Threshold ======
+====Overview====
+The command **Remove Metrics by Threshold** removes metrics above or below a threshold, allowing you to keep those within the range, or outside the range. This can be useful when trying to isolate data within a certain signal range, or when trying to isolate outliers. If a component is removed, all components at that frame are removed. The command can be found within the **Pipeline Workshop** under **Metric**.
-||
+====Pipeline Command====
-Removes metrics above or below a threshold, allowing you to keep those within the range, or outside the range.
+The syntax for the function is as follows:
-If a component is removed, all components at that frame are removed.
+<code>
+Remove_Metrics_By_Threshold
-\\
+! /METRIC_FOLDERS=
+/METRIC_NAMES=
+/METRIC_COMPONENTS=
+! /REMOVE_METRICS_ABOVE=
+! /REMOVE_METRICS_BELOW=
+;
+</code>
+====Command Parameters====
+The following table shows the command parameters seen above and their descriptions:
 |**Remove_Metrics_By_Threshold**|                                          |
 |**/Metric_Names=**             |The names of the metrics                  |
@@ Line 17: / Line 27: @@
 |**/Remove_Metrics_Below=**     |An Expression)                            |
+====Example====