Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:signal_commands:computing_the_dimensions_of_the_caltester_rod [2024/06/14 17:29] – created sgranger
+++ visual3d:documentation:pipeline:signal_commands:computing_the_dimensions_of_the_caltester_rod [2024/07/17 15:46] (current) – created sgranger
@@ Line 1: / Line 1: @@
+====== Computing the Dimensions of the CalTester Rod ======
 The dimensions of the CalTester Rod can be computed from Motion Data using the Functional Joints Landmarks.\\
-[[File:CalTesterToolbar.jpg|{{/images/a/ac/CalTesterToolbar.jpg?334x43}}]]\\
+{{:CalTesterToolbar.jpg}}\\
 Select the CalTester Dimensions Icon from the Toolbar\\
-[[File:ComputeDimensionsPP.jpg|{{/images/6/64/ComputeDimensionsPP.jpg?395x610}}]]\\
+{{:ComputeDimensionsPP.jpg}}\\
@@ Line 16: / Line 18: @@
-[[File:ComputeCalTesterDimensionsPPResults.jpg|{{/images/2/29/ComputeCalTesterDimensionsPPResults.jpg?393x613}}]]\\
+{{:ComputeCalTesterDimensionsPPResults.jpg}}\\
@@ Line 28: / Line 30: @@
-[[File:CalTesterDimensionsPPresults.jpg|{{/images/5/56/CalTesterDimensionsPPresults.jpg?395x615}}]]\\
+{{:CalTesterDimensionsPPresults.jpg}}\\
 Note that this test was done using the MTD2 rod. Notice that the dimensions are not identical with the [[CalTester:Documentation:MTD3|Default Dimensions]] because of limitations in the motion capture system and in the functional joints calculation.
-Retrieved from ""